OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

System clock

OS10 uses NTP to synchronize the system clock with a time-serving host. If you do not use NTP, set the system time in EXEC mode. The hardware-based real-clock time (RTC) is reset to the new system time.

You can set the current time and date after you disable NTP. When NTP is enabled, it overwrites the system time.

  • Enter the time and date in EXEC mode.
    clock set 
                                        time year-month-day
                                     

    Enter time in the format hour: minute: second , where hour is 1 to 24; minute is 1 to 60; second is 1 to 60 (enter 5:15 PM as 17:15:00).

    Enter year-month-day in the format YYYY-MM-DD, where YYYY is a four-digit year, such as 2016; MM is a month from 1 to 12; DD is a day from 1 to 31.

Set time and date

OS10# clock set 18:30:10 2017-01-25

View system time and date

OS10# show clock 
                              2017-01-25T18:30:17.92+00:00
                           

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\