OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

system identifier

Sets a non-default unit ID in a non-stacking configuration.

Syntax
system identifier system-identifier-ID
Parameters
system-identifier-ID — Enter the system identifier ID (1–9)
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
The system ID is displayed in the stack LED on the front panel.
Example
OS10(config)# system identifier 1
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\