OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Telnet server

To allow Telnet TCP/IP connections to an OS10 switch, enable the Telnet server. The OS10 Telnet server uses the Debian telnetd package. By default, the Telnet server is disabled.

When the Telnet server is enabled, connect to the switch using the IP address configured on the management or any front-panel port. The Telnet server configuration is persistent and is maintained after you reload the switch. To verify the Telnet server configuration, enter the show running-configuration command.

Enable Telnet server

OS10(config)# ip telnet server enable

Disable Telnet server

OS10(config)# no ip telnet server enable

By default, the Telnet server is disabled on the default VRF. To configure the Telnet server to be reachable on the management VRF, use the ip telnet server vrf management command.

Configure Telnet server on management VRF

OS10(config)# ip telnet server vrf management

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\