OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

timers lsa arrival

Configures the LSA acceptance intervals.

Syntax
timers lsa arrival arrival-time
Parameters
arrival-time — Set the interval between receiving the LSA in milliseconds (0 to 600,000).
Default
1000 milliseconds
Command Mode
ROUTER-OSPF
Usage Information
Setting the LSA arrival time between receiving the LSA repeatedly ensures that the system gets enough time to accept the LSA. The no version of this command resets the value to the default.
Example
OS10(config)# router ospf 10
                                       OS10(conf-router-ospf-10)# timers lsa arrival 2000
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\