OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

timers

Adjusts BGP keepalive and holdtime timers.

Syntax
timers keepalive holdtime
Parameters
  • keepalive —Enter the time interval (in seconds) between keepalive messages sent to the neighbor routers, from 1 to 65535.
  • holdtime —Enter the time interval (in seconds) between the last keepalive message and declaring a router dead, from 3 to 65535.
Default
keepalive 60 seconds; holdtime 180 seconds
Command Mode
ROUTER-BGP
Usage Information
The configured timer value becomes effective after a BGP hard reset. The timer values negotiate from peers. The no version of this command resets the value to the default.
Example
OS10(conf-router-bgp)# timers 30 90
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\