OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Troubleshoot OSPFv3

You can troubleshoot OSPFv3 operations, as well as check questions for any typical issues that interrupt a process.

  • Is OSPFv3 enabled globally?
  • Is OSPFv3 enabled on the interface?
  • Are adjacencies established correctly?
  • Are the interfaces configured for L3 correctly?
  • Is the router in the correct area type?
  • Are the OSPF routes included in the OSPF database?
  • Are the OSPF routes included in the routing table in addition to the OSPF database?
  • Are you able to ping the link-local IPv6 address of adjacent router interface?

Troubleshooting OSPFv3 with show Commands

  • View a summary of all OSPF process IDs enabled in EXEC mode.
    show running-configuration ospfv3
  • View summary information of IP routes in EXEC mode.
    show ipv6 route summary
  • View summary information for the OSPF database in EXEC mode.
    show ipv6 ospf database
  • View the configuration of OSPF neighbors connected to the local router in EXEC mode.
    show ipv6 ospf neighbor

View OSPF Configuration

OS10# show running-configuration ospfv3
                                 !
                                 interface ethernet1/1/1
                                 ip ospf 100 area 0.0.0.0
                                 !
                                 router ospf 100
                                 log-adjacency-changes
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\