OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

trust dot1p-map

Creates user-defined trust map for dot1p flows.

Syntax
trust dot1p-map map-name
Parameters
map-name — Enter the name of the dot1p trust map (up to 32 characters).
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
If trust is enabled, traffic obeys the dot1p map. default-dot1p-trust is a reserved trust-map name. The no version of this command returns the value to the default.
Example
OS10(config)# trust dot1p-map map1
                                       OS10(config-tmap-dot1p-map)# qos-group 4 dot1p 5
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\