OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

trust dscp-map

Creates user-defined trust map for dscp flows.

Syntax
trust dscp-map map-name
Parameters
map-name — Enter the name of the dscp trust map (up to 32 characters).
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
default-dscp-trust is a reserved trust-map name. If trust is enabled, traffic obeys this trust map. The no version of this command returns the value to the default.
Example
OS10(config)# trust dscp-map dscp-trust1
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\