OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

trust-map

Applies a dot1p or dscp traffic class to a queue trust map.

Syntax
trust {dot1p | dscp} trust-map-name
Parameters
  • dot1p— Applies a dot1p trust map.
  • dscp—Applies a dscp trust map.
Default
Disabled
Command Mode

SYSTEM-QOS

INTERFACE

Usage Information
Use the show qos maps type [tc-queue | trust-map-dot1p | trust-map-dscp] [string] command to view the current trust mapping. You should change the trust map only during no traffic flow, and verify the correct policy maps are applied. The no version of this command returns the value to the default.
Example
OS10(config)# interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)# trust-map dscp dscp-trustmap1
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\