OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

uplink-state-group

Creates an uplink-state group and enables upstream link tracking.

Syntax
uplink-state-group group-id
Parameters
group-id — Enter a unique ID for the uplink-state group, from 1 to 32.
Default
None
Command Mode
CONFIGURATION
Usage Information
The no version of this command removes the uplink-state group.
Example
OS10(config)# uplink-state-group 1
Supported Releases
10.4.0E(R3) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\