OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

upstream

Adds an interface or a range of interfaces as an upstream interface to the uplink-state group.

Syntax
upstream { interface-type | interface-range}
Parameters
  • interface-type — Enter the interface type as Ethernet or port-channel.
  • interface-range — Enter the range of interfaces.
Default
None
Command Mode
UPLINK-STATE-GROUP
Usage Information
You cannot assign an interface that is already a member of an uplink-state group to another group. The no version of this command removes the interface from the uplink-state group.
Example
OS10(config)# uplink-state-group 1
                                       OS10(conf-uplink-state-group-1)# upstream ethernet 1/1/45-1/1/48
                                       
                                    
Supported Releases
10.4.0E(R3) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\