OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

User-configured default VLAN

By default, VLAN 1 serves as the default VLAN for switching untagged L2 traffic on OS10 ports in trunk or access mode. The default VLAN is used for untagged protocol traffic sent and received between switches, such as spanning-tree protocols. If VLAN 1 is used for data traffic for network-specific needs, reconfigure the VLAN ID of the default VLAN.

  • Assign a new VLAN ID to the default VLAN in CONFIGURATION mode (1 to 4093).
    default vlan-id 
                                        vlan-id
                                     

In the show vlan output, an asterisk (*) indicates the default VLAN.

Reconfigure default VLAN
OS10# show vlan
                                 Q: A - Access (Untagged), T - Tagged
                                 NUM    Status    Description                     Q Ports
                                 *   1      up                                        A Eth1/1/1-1/1/25,1/1/29,1/1/31-1/1/54
                                 
                                 OS10(config)# interface vlan 10
                                 Sep 19 17:28:10 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:notify], 
                                 %Dell EMC (OS10) %IFM_ASTATE_UP: Interface admin state up :vlan10
                                 OS10(conf-if-vl-10)# exit
                                 
                                 OS10(config)# default vlan-id 10
                                 Sep 19 17:28:15 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:trap], %Dell EMC (OS10) %IFM_OSTATE_DN: Interface operational
                                 state is down :vlan1
                                 Sep 19 17:28:16 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:trap], %Dell EMC (OS10) %IFM_OSTATE_UP: Interface operational
                                 state is up :vlan10
                                 
                                 OS10(config)# do show vlan
                                 Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs
                                 Q: A - Access (Untagged), T - Tagged
                                 NUM    Status    Description                     Q Ports
                                 1      down
                                 *   10     up                                        A Eth1/1/1-1/1/25,1/1/29,1/1/31-1/1/54
                                 
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\