OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

vfabric (interface)

Applies an existing vfabric to an FC interface.

Syntax
vfabric fabric-ID
Parameters
fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults
Not configured
Command Mode
INTERFACE
Usage Information

The no version of this command removes the vfabric from the FC interface.

Example
OS10(config)# interface fibrechannel 1/1/1
                                       OS10(conf-if-fc1/1/1)# vfabric 100
                                    
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\