OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

vfabric

Configures a virtual fabric (vfabric). Enable the F_Port before configuring a vfabric. You can configure only one vfabric in F_Port mode. The vfabric becomes active only when you configure the vfabric with a valid VLAN and FC map. Do not use spanned VLAN as vfabric VLAN.

Syntax
vfabric fabric-ID
Parameters
fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information

The no version of this command removes the vfabric. You can remove a vfabric only when it is not applied on any interfaces.

Example
OS10(config)# vfabric 100
                                       
                                    
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\