OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

View PBR information

Display PBR information to verify IPv4 or IPv6 configuration and view statistics.

  1. View IPv4 or IPv6 PBR policy information in EXEC mode.
    show {ip | ipv6} policy 
                                           name
                                        
  2. View the current PBR statistics in EXEC mode.
    show route-map 
                                           map-name pbr-statistics
                                        
  3. Clear all policy statistics information in EXEC mode.
    clear route-map 
                                           map-name pbr-statistics
                                        
Verify IPv4 PBR configuration
OS10# show ip policy abc
                                    Interface      Route-map
                                    -----------------------
                                    ethernet1/1/1  abc
                                    ethernet1/1/3  abc
                                    vlan100        abc
                                 
Verify IPv6 PBR configuration
OS10# show ipv6 policy abc
                                    Interface       Route-map
                                    ------------------------- 
                                    ethernet1/1/1   abc 
                                    ethernet1/1/3   abc 
                                    vlan100         abc
                                    
                                    show route-map pbr-sample pbr-statistics 
                                    route-map pbr-sample, permit, sequence 10 
                                    
                                    Policy routing matches: 84 packets 
                                 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\