OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

vlan

Associate an existing VLAN ID to the vfabric to carry traffic. Create the VLAN ID before associating it to the vfabric. Do not use spanned VLAN as vfabric VLAN.

Syntax
vlan vlan-ID
Parameters
vlan-ID — Enter an existing VLAN ID.
Defaults
Not configured
Command Mode
Vfabric CONFIGURATION
Usage Information

The no version of this command removes the VLAN ID from the vfabric.

Example
OS10(config)# interface vlan 1023
                                       10OS10(conf-if-vl-1023)# exit
                                       OS10(config)# vfabric 100
                                       OS10(conf-vfabric-100)# vlan 1023
                                       
                                    
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\