OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

vlt-port-channel

Configures the ID used to map interfaces on VLT peers into a single VLT port-channel.

Syntax
vlt-port-channel vlt-lag-id
Parameters
vlt-lag-id — Enter a VLT port-channel ID, from 1 to 1024.
Default
Not configured
Command Mode
PORT-CHANNEL INTERFACE
Usage Information
Assign the same VLT port-channel ID to interfaces on VLT peers to create a VLT port-channel. The no version of this command removes the VLT port-channel ID configuration.
Example (peer 1)
OS10(conf-if-po-10)# vlt-port-channel 1
Example (peer 2)
OS10(conf-if-po-20)# vlt-port-channel 1
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\