OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

VLTi configuration

Before you configure VLTi on peer interfaces, remove each interface from L2 mode with the no switchport command, see VLT interconnect.

  1. Enter the VLT domain ID to enter from CONFIGURATION mode.
    vlt-domain 
                                           domain-id
                                        
  2. Configure one or a hyphen-separated range of VLT peer interfaces to become a member of the VLTi in INTERFACE mode.
    discovery-interface {ethernet 
                                           node/slot/port[:subport] | ethernet 
                                           node/slot/port[:subport] -node/slot/port[:subport]}
                                        
  3. Repeat the steps on the VLT peer.

Peer 1

OS10(config)# interface ethernet 1/1/1
                                 OS10(conf-if-eth1/1/1)# no switchport
                                 OS10(conf-if-eth1/1/1)# exit
                                 OS10(config)# interface ethernet 1/1/2
                                 OS10(conf-if-eth1/1/2)# no switchport
                                 OS10(conf-if-eth1/1/2)# exit
                                 OS10(config)# vlt-domain 1
                                 OS10(conf-vlt-1)# discovery-interface ethernet1/1/1
                                 OS10(conf-vlt-1)# discovery-interface ethernet1/1/2
                                 
                              

Peer 2

OS10(config)# interface ethernet 1/1/1
                                 OS10(conf-if-eth1/1/1)# no switchport
                                 OS10(conf-if-eth1/1/1)# exit
                                 OS10(config)# interface ethernet 1/1/2
                                 OS10(conf-if-eth1/1/2)# no switchport
                                 OS10(conf-if-eth1/1/2)# exit
                                 OS10(config)# vlt-domain 1
                                 OS10(conf-vlt-1)# discovery-interface ethernet1/1/1
                                 OS10(conf-vlt-1)# discovery-interface ethernet1/1/2
                                 
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\