OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

vrrp delay reload

Sets the delay time for VRRP initialization after a system reboot.

Syntax
vrrp delay reload seconds
Parameters
seconds — Enter the number of seconds for the VRRP reload time (0 to 900).
Default
0
Command Mode
CONFIGURATION
Usage Information
VRRP delay reload time of zero seconds indicates no delays. This command configuration applies to all the VRRP configured interfaces. The no version of this command resets the value to the default.
Example
OS10(config)# vrrp delay reload 5
                                       
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\