OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

vrrp-group

Assigns a VRRP group identification number to an IPv4 interface or VLAN

Syntax
vrrp-group vrrp-id
Parameters
vrrp-id — Enter a VRRP group identification number (1 to 255).
Default
Not configured
Command Mode
INTERFACE-VRRP
Usage Information
The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address. When you delete the virtual address, the VRRP group stops sending VRRP packets. The no version of this command removes the vrrp-group configuration.
Example
OS10(conf-if-eth1/1/5)# vrrp-group 254
Example (VLAN)
OS10(conf-if-vl-10)# vrrp-group 5
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\