OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

vrrp mode active-active

Enables the VRRP peers to locally forward L3 traffic in a VLAN interface.

Syntax
vrrp mode active-active
Parameters
None
Default
Enabled
Command Mode
VLAN INTERFACE
Usage Information
The no version of this command disables the configuration. This command is applicable only for VLAN interfaces.
Example
OS10(conf-if-vl-10)# vrrp mode active-active
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\