OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

vrrp version

Sets the VRRP protocol version for the IPv4 group.

Syntax
vrrp version {2 | both | 3}
Parameters
  • 2 — Set to VRRP version 2.
  • both — Allows in-service migration from VRRP version 2 to VRRP version 3.
  • 3 — Set to VRRP version 3.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
Use the both parameter to migrate from VRRPv2 to VRRPv3. When you set the VRRP protocol version to both, the device sends only VRRPv3 advertisements but can receive either VRRPv2 or VRRPv3 packets. The no version of this command disables the VRRP protocol version for the IPv4 group.
Example
OS10(config)# vrrp version both
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\