OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

zone default-zone permit

Enables access between all logged-in FC nodes of vfabric in the absence of an active zoneset configuration. A default zone advertises a maximum of 527 members in the registered state change notification (RSCN) message.

Syntax
zone default-zone permit
Parameters
None
Defaults
Not configured
Command Mode
Vfabric CONFIGURATION
Usage Information

The no version of this command disables access between FC nodes in the absence of an active zoneset.

Example
OS10(config)# vfabric 100
                                       OS10(conf-vfabric-100)# zone default-zone permit
                                    
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\