OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

zoneset activate

Activates an existing zoneset. You can activate only one zoneset in a vfabric.

Syntax
zoneset activate zoneset-name
Parameters
zoneset-name — Enter an existing zoneset name.
Defaults
Not configured
Command Mode
Vfabric CONFIGURATION
Usage Information

The no version of this command deactivates the zoneset. After you disable an active zoneset, the zone default-zone permit command configuration takes effect. Based on this configuration, the default zone allows or denies access between all the logged-in FC nodes of the vfabric.

Example
OS10(config)# vfabric 100
                                       OS10(conf-vfabric-100)# zoneset activate set
                                       
                                    
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\