Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

advertise med softphone-voice

To advertise softphone to enable IP telephony on a computer so that the computer can be used as a phone, configure the system.

Syntax
advertise med softphone-voice {vlan-id layer2_priority DSCP_value} | {priority-tagged number}

To return to the default, use the no advertise med softphone-voice {vlan-id layer2_priority DSCP_value} | {priority-tagged number} command.

Parameters
vlan-id
Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority
Enter the Layer 2 priority. The range is from 0 to 7.
DSCP_value
Enter the DSCP value. The range is from 0 to 63.
priority-tagged number
Enter the keywords priority-tagged, the Layer 2 priority, and then the DSCP value.
Defaults
Unconfigured.
Command Modes
CONFIGURATION (conf-lldp)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.7.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series and E-Series.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\