Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

bgp add-path

Allow the advertisement of multiple paths for the same address prefix without the new paths replacing any previous ones.

Syntax
bgp add-path [send | receive | both | enable] path-count
Parameters
send
Enter the keyword send to indicate that the system sends multiple paths to peers.
receive
Enter the keyword receive to indicate that the system accepts multiple paths from peers.
both
Enter the keyword both to indicate that the system sends and accepts multiple paths from peers.
enable
Enter the keyword enable to enable add-path support support for the node.
path-count
Enter the number paths supported. The range is from 2 to 64.
Defaults
Disabled
Command Modes
  • ROUTER BGP
  • ROUTER BGP-address-family
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.8(2.0)
Introduced on the S3100 series.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.0
Introduced on the Z9000.
8.3.8.0
Introduced on the S4810.
Usage Information

Using this command recycles all current sessions.

Related Commands
  • neighbor add-path — specify that this neighbor/peer group can send/receive multiple path advertisements.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\