Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

cam-acl-egress

Allocate CAM for egress ACLs.

Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl number
Parameters
default
Reset the egress CAM ACL entries to default settings.
l2acl number
Set the number of blocks for L2 egress ACL entries.
ipv4acl number
Set the number of blocks for IPv4 egress ACL entries.
ipv6acl number
Set the number of blocks for IPv6 egress ACL entries. It must be a multiple of 2.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\