Dell Command Line Reference Guide for the S4048–ON System


clear ipv6 mroute

Clear learned multicast routes on the multicast forwarding table.

clear ipv6 mroute [vrf vrf-name] {group-address [source-address] | *}
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
group-address [source-address]
Enter the multicast group address and source address (if desired), in dotted decimal format, to clear information on a specific group.
Enter * to clear all multicast routes.
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Introduced on the C9000, S3048–ON, S3100, S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON and Z9100–ON.
Related Commands

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\