Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

clear mac-address-table

Clear the MAC address table of all MAC address learned dynamically.

Syntax
clear mac-address-table {dynamic | sticky }{address mac-address | all | interface interface | vlan vlan-id}
Parameters
dynamic
Enter the keyword dynamic to specify dynamically-learned MAC addresses.
sticky
Enter the keyword sticky to specify sticky MAC addresses.
address mac-address
Enter the keyword address then a MAC address in nn:nn:nn:nn:nn:nn format.
all
Enter the keyword all to delete all MAC address entries in the MAC address table.
interface interface
Enter the following keywords and slot/port or number information:
  • For a Port Channel interface, enter the keywords port-channel then a number.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
vlan vlan-id
Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Added support for sticky MAC addresses.
8.3.11.1
Introduced on the Z9000.
8.5.1.0
Added support for 4-port 40G line cards on the E-Series.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.1.1.1
Introduced on the E-Series.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\