Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

client-key

Configures global shared key for the trusted DAC clients.

Syntax
client—key [encryption-type] key

To remove the shared key configuration, enter the no client-key command.

Defaults
None.
Parameters
encryption-type:
(OPTIONAL) Enter either 0 or 7 as the encryption type for the key entered. The options are:
  • 0 — is the default and means the key is not encrypted and stored as clear text.
  • 7 — means that the key is encrypted and hidden.
key
Enter a string that is the key to be exchanged between the switch and RADIUS servers. It can be up to 42 characters long.
Command Modes
  • CONF-DYNAMIC-AUTH
Usage Information
  • Configure global shared key applicable for DA clients. If client configuration has shared key configured, that will take precedence.
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.14(1.0)
Introduced on the S4810 and S4820T.
9.13(0.0)
Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\