Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

contact-company

Configure the contact information for the company.

Syntax
contact-company name {company-name}[company-next-name] ... [company-next-name]

To remove the contact company information, use the no contact-company command.

Parameters
company-name
Enter the name for the company. If there are multiple words in the name, use optional additional fields.
company-next-name
(OPTIONAL) Enter the next components of the company name, up to 5 components are allowed.
Command Modes
SUPPORTASSIST
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the M I/O Aggregator and FN IOM.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0)
Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500, MXL.
Usage Information

You can configure only one contact-company.

It is not possible to remove the components of the company name. The no form of the command removes the entire contact-company entry.

This command is optional for SupportAssist service configuration.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\