Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

controller

Configures controller for the VXLAN instance on the platform.

Syntax
controller controller ID ip address port port-number tcp|ssl
Parameters
controller ID
Enter the controller ID.
ip address
Enter the IP address of the controller.
port port-number
(OPTIONAL) Enter the keyword port and the port number.

The range is from 1 to 6632. The default port number is 6632.

tcp
(OPTIONAL) Enter the keyword tcp to configure tcp connection to controller.
ssl
(OPTIONAL) Enter the keyword ssl to configure ssl connection to controller (Default).
Defaults
Disabled
Command Modes
VXLAN INSTANCE
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100–ON.
9.10(0.1P10)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S4048–ON.
9.7(0.0)
Introduced on the S6000-ON.
9.4.(0.0)
Introduced on the S6000.
Related Commands
vxlan-instance — Enable VXLAN instance configuration on the platform.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\