Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

deny ip

Disassociate the UDF in IP access-list.

Syntax
deny ip {source mask | any | host ip-address} {destination mask | any | host ip-address} udf-pkt-format name udf-qualifier-value name

To remove this filter, use the no seq sequence-number command.

Parameters
source
Enter the IP address of the network or host from which the packets were sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or noncontiguous.
any
Enter the keyword any to specify that all routes are subject to the filter.
host ip-address
Enter the keyword host then the IP address to specify a host IP address.
destination
Enter the IP address of the network or host to which the packets are sent.
udf-pkt-format name
Enter the keywords udf-pkt-format then the UDF ACL profile name.
udf-qualifier-value name
Enter the keywords udf-qualifier-value then the UDF qualifier value profile name.
Command Modes

CONFIGURATION-STANDARD-ACCESS-LIST mode

CONFIGURATION-EXTENDED-ACCESS-LIST mode

Example
Dell(config-ext-nacl)#deny ip any any udf-pkt-format ipinip udf-qualifier-value ipnip_val1
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version
Description
9.8(0.0)
Introduced on the S6000, Z9500, and S4048-ON.
Related Commands

ip access-list standard — configures a standard ACL.

ip access-list extended — creates an extended ACL.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\