Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

disable-mac-learn

Disable MAC address learning on the network port of a static VXLAN tunnel.

Syntax
disable-mac-learn remote-vtep-ip

To return to the default state of enabled, use the no disable-mac-learn command.

Parameters
remote-vtep-ip
Enter the IP address of the remote VTEP that connects to the VXLAN tunnel on which MAC learning should be disabled.
NOTE The remote VTEP should already be configured.
Defaults
Enabled
Command Modes
VXLAN-INSTANCE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command-Line Reference Guide.

Version
Description
9.14(2.3)
Introduced on the S4048–ON, S4048T-ON, S6000, S6010-ON, S6100-ON, and Z9100–ON.
Usage Information

Use the disable-mac-learn command in the VXLAN-INSTANCE mode.

NOTE
  • This command is only applicable for static VXLAN and does not work for the other modes of VXLAN (controller and nuage).
  • The remote VTEP should already be configured.
  • In case of static VXLAN VLT deployments, this configuration should be symmetric across VLT nodes.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\