Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

enable stack-unit phy temp polling

Enable physical temperature polling for 10GBase-T optical ports.

Syntax
enable stack-unit unit-number port port-number phy temp polling

To disable physical temperature polling, use the disable stack-unit unit-number port port-number phy temp polling command.

Parameters
stack-unit unit-number
Enter the keyword stack-unit then the unit-number for which you want to enable temperature polling. The range is from 1 to 6.
port port-number
Enter the keyword port then the port-number for which you want to enable temperature polling. The range is from 1 to 48.
Defaults
Enabled
Command Modes
EXEC
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(0.0)
Introduced on the S4048–ON and S5048F-ON.
Usage Information
This feature is applicable only for 10GBase-T optical ports.
NOTE It is not supported for stacking ports.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\