Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

erpm

Configure the source and destination IP address for ERPM traffic.

Syntax
erpm source-ip ip-address dest-ip ip-address [gre-protocol value]

To remove the configuration, use the no erpm source-ip IP-address dest-ip IP-address [gre-protocol value] command.

Parameters
source–ip ip-address
Enter the keywords source-ip then the source IP address in dotted decimal format.
destination–ip ip-address
Enter the keywords dest-ip then the destination IP address in dotted decimal format.
gre–protocol value
(OPTIONAL) Enter the keywords gre-protocol then the protocol type value for ERPM type monitor session. The range is from 1 to 65535.
Command Modes
MONITOR SESSION (conf-mon- sess-session-ID)
Example
DellEMC(conf-mon-sess-10)#erpm source-ip 10.10.10.1 dest-ip 5.1.1.2 gre-protocol 1111
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.11(0.0)
Introduced GRE protocol support.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\