Dell Command Line Reference Guide for the S4048–ON System


errdisable recovery interval

Configure recovery time interval to move an interface from the Err-disabled state.

errdisable recovery interval seconds

To remove the configured recovery time interval, use the no errdisable recovery interval seconds command.

interval seconds
Enter the keyword interval and the number of seconds to recover the interface from Err-disabled state. The range is from 30 to 86,400 seconds. The default is 300 seconds.
300 seconds.
Command Modes
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON, S3048–ON, S6000, S6010–ON, S5048F-ON, FN-IOM, and MXL.
Introduced on the S3100.
Usage Information
Whenever the Err-disable recovery timer is reconfigured, it will get effective only after the current timer expires. Following message is displayed after each Err-disable recovery timer configuration:
DellEMC(conf)# errdisable recovery interval 30
New timer interval will be effective from the next timer instance only.
Related Commands
errdisable recovery cause — Enable automatic recovery of an interface from the error disabled state.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\