Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

fip-snooping fc-map

Configure the FC-MAP value FIP snooping uses on all VLANs.

Syntax
fip-snooping fc-map fc-map-value

To return the configured FM-MAP value to the default value, use the no fip-snooping fc-map command.

Parameters
fc-map-value
Enter the FC-MAP value FIP snooping uses. The range is from 0EFC00 to 0EFCFF.
Defaults
0x0EFC00
Command Modes
  • CONFIGURATION
  • VLAN INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the Z9500 and S6000-ON.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\