Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

fip-snooping port-mode fcoe-trusted

Configure the port for bridge-to-bridge links. It is not recommended to use this command because multi-hop FSB is not supported.

Syntax
fip-snooping port-mode fcoe-trusted

To remove the bridge-to-bridge link configuration from the port, use the no fip-snooping port-mode fcoe-trusted command.

Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
This command is deprecated.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.16.0
Introduced on MXL 10/40GbE Switch IO Module.
Usage Information
NOTE: This command is deprecated from the Dell EMC Networking OS.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\