Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

hold-time

Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the VRRP MASTER, the new switch can stabilize its routing tables.

Syntax
hold-time {seconds | centisecs centisecs}

To return to the default value, use the no hold-time command.

Parameters
seconds
Enter the number of seconds. The range is from 0 to 65535. The default is zero (0) seconds.
centisecs centisecs
Enter the keyword centisecs then the number of centisecs in units of 25 centisecs. The range is from 0 to 65525 in units of 25 centisecs.
Defaults
zero (0) seconds or (0) centiseconds
Command Modes
VRRP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.0)
Added support for centisecs on the Z9000, S6000, S4820T, S4810, and MXL.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.2.1.1
Introduced on the E-Series.
Usage Information
If a switch is a MASTER and you change the hold timer, disable and re-enable VRRP for the new hold timer value to take effect.
Related Commands
  • disable — disables a VRRP group.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\