Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

ip access-group

Apply an egress IP ACL to the ACL VLAN group.

Syntax
ip access-group {group name} out implicit-permit
Parameters
group-name
Enter the name of the ACL VLAN group where you want the egress IP ACLs applied, up to 140 characters.
out
Enter the keyword out to apply the ACL to outgoing traffic.
implicit-permit

Enter the keyword implicit-permit to change the default action of the ACL from implicit-deny to implicit-permit (that is, if the traffic does not match the filters in the ACL, the traffic is permitted instead of dropped).

Default
None
Command Modes
CONFIGURATION (conf-acl-vl-grp)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.3.(0.0)
Introduced on the S4810, S4820T, and Z9000 platforms.
Usage Information
You can apply only an egress IP ACL on an ACL VLAN group.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\