Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

ip pim rp-address

Configure a static PIM rendezvous point (RP) address for a group or access-list.

Syntax
ip pim [vrf vrf-name] rp-address address {group-address group-address mask} [override]

To remove an RP address, use the no ip pim [vrf vrf-name] rp-address address {group-address group-address mask} [override] command.

Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF.
NOTE Applies to specific VRF if input is provided, else applies to Default VRF.
address
Enter the RP address in dotted decimal format (A.B.C.D).
group-address group-address mask
Enter the keywords group-address then a group-address mask, in dotted decimal format (/xx), to assign that group address to the RP.
override
Enter the keyword override to override the BSR updates with static RP. The override takes effect immediately during enable/disable.
NOTE This option is applicable to multicast group range.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF. Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series.
7.8.1.0
Introduced on the S-Series.
pre- 6.1.1.1
Introduced on the E-Series.
Usage Information
First-hop routers use this address by to send register packets on behalf of source multicast hosts. The RP addresses are stored in the order in which they are entered. The RP is chosen based on a longer prefix match for a group. The RP selection does not depend on dynamic or static RP assignments.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\