Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

ip ssh rekey

Configures the time rekey-interval or volume rekey-limit threshold at which to re-generate the SSH key during an SSH session.

Syntax
ip ssh rekey [time rekey-interval] [volume rekey-limit]

To reset to the default, use no ip ssh rekey [time rekey-interval] [volume rekey-limit] command.

Parameters
time minutes                
Enter the keywords time then the amount of time in minutes. The range is from 10 to 1440 minutes. The default is 60 minutes
volume rekey-limit        

Enter the keywords volume then the amount of volume in megabytes. The range is from 1 to 4096 to megabytes.  The default is 1024 megabytes

Defaults
The default time is 60 minutes. The default volume is 1024 megabytes.
Command Modes
CONFIGURATION mode
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.5(0.1)
Introduced on the Z9500.
9.5(0.0)
Introduced on the Z9000, S6000, S4820T, S4810, MXL

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\