Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

ipv6 control-plane icmp error-rate-limit

Configure the maximum number of ICMP error packets per second that can be sent per second.

Syntax
ipv6 control-plane icmp error-rate-limit {1-200}

To restore the default value, use the no ipv6 control-plane icmp error-rate-limit command.

Parameters
pps
Enter the maximum number of error packets generated per second. The range is from 1 to 200, where 0 disables the rate-limiting.
Default
100 pps
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant DellEMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\