Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

ipv6 ospf dead-interval

Set the time interval since the last hello-packet was received from a router. After the time interval elapses, the neighboring routers declare the router down.

Syntax
ipv6 ospf dead-interval seconds

To return to the default time interval, use the no ipv6 ospf dead-interval command.

Parameters
seconds

Enter the time interval in seconds. The range is from 1 to 65535 seconds.

Defaults
40 seconds (Ethernet).
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.1.(0.0)
Introduced on the S4810 and Z9000.
7.8.1.0
Added support for C-Series.
7.4.1.0
Introduced on the E-Series.
8.3.19.0
Introduced on the S4820T.
Usage Information

By default, the dead interval is four times longer than the default hello-interval.

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\