Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

iscsi priority-bits

Configure the priority bitmap that advertises in the iSCSI application TLVs.

Syntax
iscsi priority-bits

To remove the configured priority bitmap, use the no iscsi priority-bits command.

Defaults
4 (0x10 in the bitmap)
Command Modes
PROTOCOL LLDP (only on the global, not on the interface)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.10(0.0)
Introduced on the S3148.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.16.0
Introduced on MXL 10/40GbE Switch IO Module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\