Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

local-vtep-ip

Set the local IP Address to be used as the source IP for VXLAN tunnels.

Syntax
local-vtep-ip IP Address

To disable the settings, use the no local-vtep-ip command.

Parameters
IP Address
Enter the local IP Address to be used as a source for VXLAN tunnels.
Defaults
None.
Command Modes
VXLAN INSTANCE
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
Usage Information
Use the local-vtep-ip IP Address command to set the local IP Address that would be used as source for VXLAN tunnels.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\