Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

mac learning-limit learn-limit-violation

Configure an action for a MAC address learning-limit violation.

Syntax
mac learning-limit learn-limit-violation {log | shutdown}

To return to the default, use the no mac learning-limit learn-limit-violation {log | shutdown} command.

Parameters
log
Enter the keyword log to generate a syslog message on a learning-limit violation.
shutdown
Enter the keyword shutdown to shut down the port on a learning-limit violation.
Defaults
None
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Introduced on the S-Series.
7.8.1.0
Introduced on the C-Series.
7.5.1.0
Introduced on the E-Series.
Usage Information
This command is supported on physical interfaces, static LAGs, and LACP LAGs.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\