Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

maximum dynamic-routes

Specify the maximum number of dynamic (protocol) routes a VRF can have.

Syntax
maximum dynamic-routes limit {warn-threshold threshold-value | warning-only}

To remove the limit on the maximum number of routes used, use the no maximum dynamic-routes command.

Parameters
limit
Maximum number of routes allowed in a VRF. The valid range is from 1 to 16,000 (or maximum allowable for that platform if a smaller value).
warning-threshold
The warning threshold value is a percentage of the limit value. When the number of routes reaches the specified percentage of the limit, a warning message appears. The valid range is from 1 to 100.

After the limit is reached, additional dynamic routes are not allowed.

warning-only
When you use the warning-only option, when the maximum number of dynamic routes reaches the limit, a warning message appears.

After the limit is reached, additional dynamic routes are still allowed.

Defaults
No limit is set on the maximum number of dynamic routes for a VRF.
Command Modes

CONFIGURATION-VRF

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON and Z9500.
9.4(0.0)
Introduced on the S–Series.
Usage Information

If you do not specify the maximum route limit for a VRF, the VRF has unlimited space that extends to the maximum number of entries allowed for the system.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\