Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

neighbor next-hop-self

Allows you to configure the router as the next hop for a BGP neighbor.

Syntax
neighbor {ip-address | peer-group-name} next-hop-self [all]

To return to the default setting, use the no neighbor {ip-address | peer-group-name} next-hop-self [all] command.

Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group.
all
Specifies that the route reflector is the next hop for both iBGP and eBGP-learned routes.
Defaults
Disabled.
Command Modes
ROUTER BGP
Command History
Version
Description
9.10(0.0)
Introduced the all keyword on the S4810, S4820, S4048–ON, S3048–ON, S3100 series, S6010–ON, S4040T-ON, S5000, S6000, S6000–ON, S6100–ON, Z9100–ON, and Z9500.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
Usage Information

If you configure the set next-hop command in ROUTE-MAP mode, the configuration takes precedence over the neighbor next-hop-self command.

If you do not use the all keyword, the next hop of only eBGP-learned routes is updated by the route reflector. If you use the all keyword, the next hop of both eBGP- and iBGP-learned routes are updated by the route reflector.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\